Album: Modeling 303

Right side after second coat. About five minutes after application, I went back with a paper towel dabbed in paint thinner to carefully remove it in spots on both sides where, on the prototype, the second coat has given way to the first. I avoided the decaled areas at this time. After it was completely dry, I went back with the edge of some very fine grit sandpaper and carefully removed the second coat from select areas of the lettering, again based on prototype photos below.
By: Joe Atkinson

Modeling 303 navigate UP (accesskey 'U')
Right side after second coat. About five minutes after application, I went back with a paper towel dabbed in paint thinner to carefully remove it in spots on both sides where, on the prototype, the second coat has given way to the first. I avoided the decaled areas at this time. After it was completely dry, I went back with the edge of some very fine grit sandpaper and carefully removed the second coat from select areas of the lettering, again based on prototype photos below.
First Photo (Accesskey 'F') Previous Photo (Accesskey 'P') 3 of 16 Next Photo (Accesskey 'N') Last Photo (Accesskey 'L')
Jump to:
All images on this site are copyrighted by their respective creators, and used with permission.
All Iowa Interstate logos and trademarks are property of Iowa Interstate Railroad, Ltd. and Railroad Development Corporation.
Questions? Comments? Please email us at contact@iaisrailfans.org
  Last modified on April 26, 2010, at 11:40 PM